RELM PM4500 Bedienerhandbuch

MODEL PM4500PROGRAMMERProgramming Mini-Corn@ PlusSM Series TransceiversRESTRICTED TO DEALER USE ONLY.USE BY PERSONS OTHER THAN DEALERS IS8NAUTHORlZED

6. a. Enter a single digit code corresponding to thedesired BCL status.BCL No = 0BCL Yes = 1The display will show, for example:- Blinkingb. Enter a th

Press ENTER to store Transmit Frequency inmemory. The display will advance to TX ToneTable 5. PM4500 CCode. -8. TX Tone CodeDisplay will show, for e

Table 6. PM4500 Codes ws. DCS* Codes.Table 6. PM4500 Codes vs. DC!2 Codes(Cont’d).DCS CodeDCS CodeINV‘M450STD‘h+l4500codaJVSTD22322522624324424524

Table 6. PM4500 Codes ws. DCS’ Codes(Cont’d).121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154D

24Press and hold ESCAPE. The Programmer’sdisplay will show a characteristic Test Pattern withall segments on, thus:and then revert to:in the display

If the data to be duplicated (cloned) is NOT alreadyin a Transceiver, proceed as follows:1. Connect the PM4500 to the Transceiver to beprogrammed usi

An IErM@ PC-compatible computer with a serialport can be used for all programming and cloningfunctions the same as the PM4500. Consult thefactory for

Welcome to the RELM Communications family ofprofessional two-way radios and systems, and thankyou lor purchasing one of our fine products. Weare confi

This manual contains instructions for using the PM4500Programmer (simply referred to as the Programmer) toprogram the Mini-Corn@ Plus 16 and 99 Channe

A description of the 20 keys follows:CHANNELPress this key and a digit key(s) to access a chan-nel.OPTIONSUse this key for programming and reviewing t

NOTES:1. Each time a Programmer key is pressed, abeep will be heard if an external speaker isplugged into the SM Series Transceiver.2. If an invalid n

5. Priority Delay.Display will show, for example:B/inking 26. Enter a value 0, 1, 2 or 3. (See Table 2, page 7.)Press ENTER to store Priority Delay

15. Power Up on Channel 1.The display will show one of the following:Blinking 2Blinking 3‘16. Press TOGGLE key to toggle Y (Yes) to N (No)or vice vers

WARNING: The Transceiver’s proper Range isdetermined at the time of manufacture. It shouldNOT be programmed unless components thataffect the Unit’s me

a. To delete the channel at this time,press DELETE. The display will show:For UHF models, the display will show one of thefollowing:Blinking -I- Blin